Ashtech ProMark 200 Especificaciones descargar pdf (Pagina 44)

English

You can view the Hor. correction and Ver correction tabs

showing the characteristics of the local system, as

currently determined by the process.

• When you are pleased with the results of the process (i.e.

all residuals are zero or close to zero), then you can make

the local system the new coordinate system used in the

job by tapping OK.

Note that the coordinates displayed at the bottom of the

screen now reflect the change of coordinate system.

• If you select Menu>Job>Properties and you open the

Coordinate System tab, you will notice that the name of the

coordinate system used is now “Fitted” and the projection

and vertical datum are unchanged compared to the

coordinate system originally used in the job.

NOTE: After the local coordinate system has been

determined and validated in a job, there is no way you can

revert to the coordinate system initially defined for the

job.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 59 60

Sin comentarios

Ashtech ProMark 200 Especificaciones Pagina 44